At some point in your life you will probably have to call a plumber. Although the sanitary systems in our houses are designed for durability, there is damage. Regardless of whether it is a small leak, a running toilet, or a backup of the sewage system, all installation problems should be resolved soon after they are discovered.
Here are the most common installation problems and some tips on what to do if they occur:
1) drip taps
Dripping taps are all too common and people tend to ignore them. But a dripping tap can not only annoy you. This will also be the reason for an increase in your water bill. Dripping taps, if left untouched for a year, can waste hundreds of gallons of water. It is important to contact a reliable plumber like Estes Services if you notice an installation problem. From dripping taps to major leaks, installers are committed to resolving these problems quickly.
2) Clogged drains
It makes sense that the drains clog up after prolonged use. Hair and soap accumulations collect and prevent water flow. If you don't solve the problem quickly, it will only make it worse. You can use baking, soda, and vinegar to dissolve anything that clogs the drain. You may also need to use a piston or a snake. If you choose to use a piston, improve its seal by adding petroleum jelly to the edge of the suction cup. Make sure there is enough water in the shower to immerse the end of the plunger.
3) Water heater malfunction
You won't notice this problem until you step into the shower and the water suddenly becomes cold. In this case there is probably a problem with your water heater. This can be due to a number of causes, e.g. B. the extinction of the pilot light or the accumulation of sediments in the tank. The best way to handle this is to contact a plumber immediately. But if it's a simple solution, like reigniting your pilot light, you can do it yourself.
4) Bad water pressure
If the water does not come out of the tap in a steady flow, but slowly runs out, you are dealing with a low water pressure. Older houses experience this more often. The problem is caused by leaky pipes that have corroded over time. The problem is more often caused by sediment accumulation and mineral deposits on aerators.
If the problem occurs while showering, disassemble the shower head and remove soap and dirt deposits. Take a toothbrush soaked in vinegar and scrub the shower head to remove the mineral deposits. Then use a safety pin or other pointed object to remove loose deposits. Soak the shower head parks in vinegar overnight.
5) sewage protection
Sewage protection is one of the most nightmarish installation problems. Not only do they smell of poultry and are impractical, they can also be expensive to repair.
The three most common causes are:
- A main channel lock
- Tree roots grow in the pipes
- Age and decay
If some of the drains and toilets in your room aren't working properly and you smell human waste, it's probably because of a fuse. However, sometimes a sewage system backup is caused due to a blockage outside of your property. If the problem occurs on public roads, the water supply will fix it.
Therefore, it is important to call the water supply before consulting a plumber. If it's their fault, you don't have to pay a plumber to track down the blockage.