Have you ever thought about checking the security of your home's wiring? Here's Why You Should Today!
Photos by: Unsplash
A different wiring system was used in houses from the early half of the 20th century than in today's houses. In houses being built today, circuit breakers are used to control the electrical circuits in the house. In the past, however, Knauf Pipe cabling connected to a fuse box was the only electrical system available. These old wiring systems use 2 wires separated by insulating buttons so they don't touch. No ground wire is used when wiring buttons and tubes. Never try to troubleshoot your button and pipe wiring yourself. If you need electrical repair utahCall a licensed electrician.
Is button wiring safe?
Button-and-tube wiring is old and has no reason, but that doesn't necessarily make it unsafe. The main danger is to your devices and electronics when they are exposed to a power surge. A modern home has a ground wire that runs deep into the ground with the wiring to conduct voltage spikes out of the home. You can reduce the risk of damage from voltage spikes by installing RCDs that turn off the power supply when they sense a power surge. Older systems, just like modern electrical systems, can have problems that pose a hazard. If you suspect there is a problem, contact a professional. A button and tube electrical repair is possible in Utah.
Problems with Knob and Tube
There are a few common problems you might be able to identify without even handling the cabling system. Pay attention to the following:
- Exposed metal in the wiring due to damaged insulation
- Unsoldered splices
- Fuses in the fuse box with high amperage that would be over 20
Any of these situations can be hazardous and should be checked by a certified Utah electrical repairer.
Replacing the button and tube
The insulation around the Knauf pipe cabling consists of rubber or fabric covered with asphalt. Both materials will deteriorate over time. So if you plan to be staying in your home for an extended period of time, consider upgrading the wiring. Plus, button and pipe wiring was never intended to handle the electrical loads of the modern homeowner. Update of the wiring is something that can be done over time. You can even do it individually to make it more affordable. At the moment your old wiring may be fine. If you are about to move into a new home, have the wiring checked for wear. If there is a problem, a licensed team can perform your electrical repair in Utah.
