While it's easy enough to buy a kayak stand for one or more kayaks, it's much more economical and creative to make one at home. It is therefore helpful to get the right material quality in addition to clear instructions in order to be able to create a simple, inexpensive option at home.
A DIY kayak stand It takes barely 20 minutes to half an hour for inexperienced people, and is well below $ 30, which ensures you save a lot of money in the process.
Essential materials
There are a few tools that are essential for the easy DIY stand of your kayak: They are as follows:
- A tape measure
- Strong marker
- A rubber mallet
- A pair of ratchet pipe cutters or a hand saw, though they tend to cause more dirt when cleaning.
In addition to the tools mentioned above, you also need to get the right materials for the stand. The following materials are required:
- Two inch wide PVC hose that is ten feet long
- Two "X" connectors
- Four "T" ports
- Eight inch wide PVC caps
- Light and thin bracelet that is durable
- A knife
- PVC cement
Step 1: measure and cut
- Cut out 4 pieces of PVC tubing, each 16 inches long
- Repeat this with 8 pieces of PVC tubing, each 7 inches long
- Repeat this with 2 pieces of 5 feet each
Step 2: "X" connectors
The PVC cement must be applied to the inside of the "X" connections. This should be done in a well ventilated area to avoid toxic fumes. Before installation, it is imperative that part of the cement is applied to the sides of the pipes that enter the connection.
Next, take the two previously cut 16-inch PVC pipe lengths and attach them to the connector to form a "V" in one direction. Repeat the process on the other side and attach two more of the 7 inch hoses to create a smaller "V". It takes just a few minutes to dry the cement and should be set aside.
Step 3: assembly
Before each connection is cemented, a dry run must be carried out and assembled. The rest is easy to follow.
The smaller "V" from the 7-inch tubes can now be connected to the "T" connector. Make sure that they point in the right direction before sticking the 7 inch pieces onto the "T".
Attach two more 7-inch PVC pipes to the T-connectors. You can then attach the PVC caps to the base.
Use the knife to cut long ribbons to attach them to the open ends of the 16-inch tube. Use the caps to secure the straps in the 16-inch tubes using the rubber mallet. Repeat this process until the "X" for the other side is also complete.
It's time to attach the 5 foot PVC hose. Attach it to the two "X" for the front and back, which have been equipped with the straps. Attach the two ends of the 5-foot pipe to the "T" connectors on the "X". Repeat with the other 5 foot tube to complete the stand.
If you want to cement the entire structure, this is an option. However, it is not a collapsible option for better storage when not in use. These do not wear out easily, although the straps can warp over time.
The best option for kayakers
These DIY kayak stand is simple and robust and can easily take up to 16 feet of tandem. The kayaks should be stored upside down on the stand outdoors. If you are interested in improving your fishing kayak to improve your kayaking experience, you should give it a try. Remember upgrades like one DIY kayak stand are an inexpensive and simple option and offer an inexpensive storage solution.
